Connect an RCA stereo cable from the "Audio Out" of your source device to the "AUX" or "DVD" inputs on the rear panel of the JBL RMA 220.
Plug your wired or wireless microphone receivers into the front or rear mic input jacks.
Speak into the microphone and slowly increase the individual Mic 1 Gain control until your voice is clearly audible. Adjust the to balance the tone:
| Parameter | Value | |-----------|-------| | Power (8Ω, stereo) | 220W x 2 | | Power (4Ω, stereo) | 350W x 2 | | Power (8Ω, bridge) | 700W x 1 | | Frequency response | 20Hz – 20kHz (±0.5dB) | | THD+N | <0.05% (typical) | | SNR | >100 dB (A-weighted) | | Damping factor | >200 @ 1kHz, 8Ω | | Dimensions (WxHxD) | 483 x 89 x 300 mm (19" x 3.5" x 11.8") | | Weight | 8.5 kg (18.7 lbs) |
Built-in digital echo and reverb effects tailored for vocal clarity.
Press the Power switch. The status LED indicator should light up. 4. Audio Fine-Tuning and Calibration
• Raise the specific MIC Vol knob on the front panel.• Check the batteries or power switch on the mic.• Swap the microphone cable with a known working one.
Connect an RCA stereo cable from the "Audio Out" of your source device to the "AUX" or "DVD" inputs on the rear panel of the JBL RMA 220.
Plug your wired or wireless microphone receivers into the front or rear mic input jacks. jbl rma 220 user manual
Speak into the microphone and slowly increase the individual Mic 1 Gain control until your voice is clearly audible. Adjust the to balance the tone: Connect an RCA stereo cable from the "Audio
| Parameter | Value | |-----------|-------| | Power (8Ω, stereo) | 220W x 2 | | Power (4Ω, stereo) | 350W x 2 | | Power (8Ω, bridge) | 700W x 1 | | Frequency response | 20Hz – 20kHz (±0.5dB) | | THD+N | <0.05% (typical) | | SNR | >100 dB (A-weighted) | | Damping factor | >200 @ 1kHz, 8Ω | | Dimensions (WxHxD) | 483 x 89 x 300 mm (19" x 3.5" x 11.8") | | Weight | 8.5 kg (18.7 lbs) | Adjust the to balance the tone: | Parameter
Built-in digital echo and reverb effects tailored for vocal clarity.
Press the Power switch. The status LED indicator should light up. 4. Audio Fine-Tuning and Calibration
• Raise the specific MIC Vol knob on the front panel.• Check the batteries or power switch on the mic.• Swap the microphone cable with a known working one.