| TimeTec has merged all of its solutions into www.timeteccloud.com, click to |
Connect the AC power cord to a grounded outlet and flip the mains switch. The system will auto-detect the camera and initiate the optical handshake before applying high-voltage power. 4. Operational Configuration
Safe connection confirmed; high voltage applied successfully.
| Symptom | Probable Cause | Solution | | :--- | :--- | :--- | | | 1. Power off. 2. Cable disconnected. 3. Brightness turned down. | 1. Check Camera/CCU power. 2. Reseat VF cable. 3. Increase Brightness knob. | | Image is Blurry | 1. Viewfinder Focus Ring is misadjusted. 2. CRT failing. | 1. Adjust the external focus ring. 2. If the "glow" looks fuzzy even with focus maxed, the CRT may be at end-of-life. | | Horizontal Bar Rolling | 1. 50Hz/60Hz hum interference. 2. Ground loop. | 1. Check power source grounding. 2. Move away from strong magnetic fields. | | Image is "Washed Out" | 1. Contrast too low. 2. Ambient light leaking into eyepiece. | 1. Increase Contrast. 2. Press eye against eyecup firmly. | | Burn-in on Screen | Static image left on for hours. | CRT phosphor burn is permanent. The unit functions but will have "ghost" images. Replace CRT. |
Since the official manual is a copyrighted technical document (typically 50+ pages), this guide provides the critical functional overview, setup logic, and troubleshooting steps that a broadcast engineer or camera operator would need. You will still need the physical manual for pinouts and board-level schematics.
Route a control cable from your Ikegami OCP (Operational Control Panel) to the Remote port.
