Wittmann Tempro Plus D 360 Manual «Top 20 HIGH-QUALITY»

: The 360 model typically utilizes powerful, maintenance-free magnetically coupled pumps designed for pressurized operation. Visual Interface

| Symptom | Possible Cause | Suggested Action | | :--- | :--- | :--- | | | Scale buildup in heat exchanger; undersized heater element. | Perform a descaling procedure (see maintenance section of manual). Check heater contactors. | | Pressure Fluctuations | Low water level; air in the system; faulty pressure sensor. | Check and refill water level. Run an air purging cycle. Monitor pressure gauge for anomalies. | | Unit Not Reaching Setpoint | Incorrect pump speed setting; external load exceeding capacity. | Adjust pump speed (EcoDrive models) to increase flow. Verify mold requirements against unit specs. | | Touchscreen Unresponsive | Software lockup; hardware fault. | Power cycle the unit. If persistent, consult the troubleshooting guide for control board diagnostics. | | Leakage | Worn pump seals (if not mag-coupled); loose connections. | Inspect all fittings immediately. For seal replacement, refer to the unit's exploded parts diagram. | Wittmann Tempro Plus D 360 Manual

The direct cooling valve response is adjustable via “Cooling gain” (0.50 to 2.00). Default = 1.00. Check heater contactors

Confirm the electrical supply matches the unit's voltage requirements. The Tempro Plus D 360 Run an air purging cycle