Elstat Ems 25 Advanced Manual 〈100% PRO〉

Press and hold the Set (snowflake) button until the display shows "PAS" . Input Sequence: Press Set four times ( x4 ). Press the Up Arrow once ( x1 ). Press the Down Arrow twice ( x2 ). Press the Defrost/Teach button twice ( x2 ).

When navigating inside the parameter configuration section (), the display flashes between the setting mnemonic and its current numerical value. Use the Up/Down buttons to alter variables and tap Set to jump to the next entry. Function Name Description Range Options CF Temperature Scale Switches readout variables between regional units. 0 (°C) / 1 (°F) SPC Operational Set Point Target temperature when the store is open and active. -9.9 to 9.9°C dIF Temperature Differential Elstat Ems 25 Advanced Manual

| Terminal | Function | Advanced Tip | | :--- | :--- | :--- | | 1-2 | Power Supply (L-N) | Use a dedicated circuit. Do not share neutral with high-inductive loads without a filter. | | 3-4 | Compressor Relay (NO) | For inductive loads (compressors >1HP), install an external contactor. The internal relay is rated for 16A resistive. | | 5-6 | Defrost Relay (Heating) | If using electric defrost, ensure the relay switches the contactor coil, not the heater directly. | | 7-8 | Evaporator Fan Relay | Fan delay parameters (FON / FOFF) rely on this connection. | | 9-10 | Probe Input (Sonda) | Polarity matters for PTC probes. Red wire to terminal 9 (signal), black to 10 (ground). | | 11-12 | Digital Input (Door) | Use volt-free contacts. Parameter i2P determines if NC (normally closed) or NO (normally open). | Press and hold the Set (snowflake) button until

The EMS 25 Advanced toggles between three distinct operating modes to balance beverage quality with maximum energy savings. Active Mode Press the Down Arrow twice ( x2 )

Probe failure. Indicates a fault with the appliance or condenser sensor.